How To Fix Burn Marks On Carpets

 While routine floor cleaning, did you notice a burn mark on your carpet recently in Fort Worth?

Carpet burns are a common issue many homeowners face. Routine carpet cleaning in Arlington, Hurst, or Fort Worth cannot remove the burn marks. It calls for a carpet repair job. Whether burns occur due to an electrical short circuit, negligent flat iron placement, candle or a matchstick drop, or anything else, it damages your carpet permanently. Decide to fix it yourself or call the professionals for the job based on the size and severity of the burn. Remove the flammable material immediately and follow these steps to fix burn marks on your carpet.

Steps to Fix Burn Marks on Carpets

1) Assess severity of the burn

In minor cases, only the tip of the carpet fibers shows burn marks. Closely check before carpet cleaning in Arlington, Hurst, or Fort Worth. Gently sand or trim the singed fiber tips away using fine-grit sandpaper. If you can see the carpet padding or even the subflooring instead of the carpet fibers, note that it is a severe case of carpet burn. It requires a trained professional to fix such burn marks.

2) Gather up necessary tools for repair

Whatever caused the burn marks, remember all severe cases require the same process of fixing them. If you are confident with tools, do the repairs otherwise, avoid them.

List of Tools for Repair

●      Fine grit sandpaper

●      Standard printer paper piece

●      Sharp scissors with a pointed end that can cut carpet

●      Pencil

●      Razor knife

●      Double-sided carpet tape/ Latex adhesive

●      Replacement carpet piece to cover the burnt area

3) Remove damaged carpet

Use a razor knife to cut out the burn area. Avoid cutting deep if the underlayment or subfloor of the carpet is burn-free.

4) Do carpet cleaning

Use a vacuum to clear debris in the affected area. Do carpet cleaning gently with soap and water to remove smoke, wax, or other substances from your carpet in Arlington, Hurst, or Fort Worth.

5) Prepare carpet patch

Take the standard printer paper piece and pencil, place it over the affected carpet area, and create a stencil to trace the size of your carpet patch.

6) Cut the piece of replacement carpet and do the patching

Use sharp scissors to cut the replacement carpet patch. Ensure it perfectly matches the stencil. Apply latex adhesive or your double-sided carpet tape on the back of your carpet patch and insert it into the burn area. Press and hold it for several seconds. Avoid walking on it for 24 hours.

Conclusion

When in doubt about fixing the burn marks on your carpet, hire a commercial carpet cleaning and repair expert for the job in Fort Worth/Arlington/Hurst. Always mention stains or burns that you need to fix when googling carpet cleaning services near me. Choose the day of service according to your convenience and get a complete cost estimate before commencing the task.